Fan Switch Sub-Harness for K-Swap This will delete your need

This will delete your need for the factory oem igniter without having to cut or splice into the factory harness

A Plug & Play solution wrapped in a braided glass fiber sleeving for running a K24 Knock sensor on a K20 engine harness

Harness Features:

Cable from Battery Positive + to Starter

Fan Switch Sub-Harness for K-Swap This will delete your needLooking to run a Fan Switch on your K Swapped Honda? We have the solution for you! For a clean install, simply plug our harness into your fan switch using the pre wired connector On your connector you have two wires one is a 30cm earth strap to be connected a suitable ground point on your chassis, the other is 200cm in length and covered in a black braided sleeving for a high quality finish in your engine bay, this is ran to your conversion harness